Mantel Kit Installation - Easy to Install

Step #1

Make sure your floor is clean, then turn the mantel breast assembly upside down on the floor.

Step #2

Step #3

Step #4 - Outline The Mantel

After you have assembled your mantel, place it on the wall where it will be permanently positioned. Lightly outline the mantel on the wall as shown. Then move the mantel to the side.

Step #5 - Install Mounting Strips 1/2” or 3/4” Inside of Lines

Install the mounting strips inside your lines either 1/2” or 3/4” depending on the thickness of your mantel. Secure mounting strips to the wall by nails, screws, and construction adhesive. Side mounting strips can be attached to the bottom plate of the wall if there are no studs where the strip is located.

Step #6 - Install Mantel Over Mounting Strips

Use a construction adhesive on the mounting strips before putting the mantel on the wall. This will give you a permanent application. Place the mantel on the wall over the mounting strips. Nail mantel to mounting strips in positions shown below. Predrill holes and fasten with finish nails. (When using nail guns predrilling is not necessary).

Step #7 - Install Scribe Moulding

Install scribe moulding inside the mantel opening. (You may need to trim the scribe moulding to fit after you install the mantel.) Predrill holes first, then glue and nail scribe moulding into place. Some styles have the scribe moulding preattached.